石景山區PVC排水管-Gafloon卡弗龍-PVC排水管制造

• 供貨總量 : 不限
• 價格說明 : 議定
• 包裝說明 : 不限
• 物流說明 : 貨運及物流
• 交貨說明 : 按訂單

鋪設好的冷熱水管一定要用卡扣固定好，PVC排水管生產，避免后期裝修過程中水管移位，導致接頭脫落、松動，產生漏水隱患。盡量做到每隔60cm就要安裝一個卡子，切記卡子安裝一定要牢固。成品保護很重要，鋪設的水管，避免有重物壓在水管上。

Water pipe le

The laid cold and hot water pipe must be fixed with clamps to avoid the displacement of the water pipe in the later decoration process，石景山區PVC排水管， which leads to the joint falling off and loosening， and the potential water leakage will occur. Try to install a clip every 60cm，PVC排水管制造， and remember that the clip must be firmly installed. The finished product protection is very important. The water pipe laid should be protected from heavy loads on the water pipe.

ppr管熱熔操作

熱熔器接通電源，到達溫度指示燈亮后方能開始操作。

切割管材必須使端面垂直于管軸線，管材切割一般使用管子剪，如為大管徑，則用鋸條切割，切割后斷面去毛刺和毛邊。

Hot melt operation of PPR pipe

The heat melt can be operated after the power is turned on and the temperature indicator light is on.

The end face of the pipe must be perpendicular to the pipe axis. Pipe cutting is generally used. If the pipe diameter is large， it is cut with a saw blade. After cutting， the sected shall be deburring and burr free.

水電不同槽

水路和電路不要同槽，如果發生漏水，或者產生冷凝水時，容易浸泡到電線，這是非常危險的，好相距10cm以上。如果有水電交叉的時候，水下電上。

Different hydropower tanks

Water circuit and circuit should not be the same as the groove. If water leakage or condensate water is produced，PVC排水管加工， it is easy to soak into the wire. This's very dangerous， and it is better to be more than 10cm apart. If there is a water and electricity crossing， the underwater power is on.